GetResponse Setup
As with the previous options, the first step is choosing your preferred list management application, in this case GetResponse.
To select it, you simply need to click the radio button next to GetResponse. Having made your selection you should now click the button labeled "Next". Clicking in the Next button will load the following screen with instructions:
If you don't already have a GetResponse account, you can get one by going to www.getresponse.com
Once you are logged in to GetResponse, in order to channel your customer data efficiently (and to enable the sending of tailored messages to specific groups of customers, at differing stages of your sales process), you need to setup three separate lists by clicking on the Campaigns header and then on the Create Campaign button.
1. Paid Customer List
Create a list with a name like abcd-customer where abcd is an identifier that makes the name unique to you (GetResponse will tell you if the name is already being used).
Fill out the rest of the information and save it.
2. Free Customer List
Create a list with a name like abcd-free.
Then on the drop-down for the Campaigns header, click on Automation.
Create a remove rule that will remove users from this list when they subscribe to the Paid Customer List.
3. Prospects List
Create a list with a name like abcd-prospect.
Then, go to the automation section again and create two remove rules that tell the system to remove people from the list if they subscribe to the Paid Customer list, and to remove them if they subscribe to the Free Customer List.
Note: Unfortunately, with GetResponse is not possible to create the custom fields needed to send out a review request message.
After following exactly the steps above, click on the "Next" button found at the bottom left of the screen.
This will load the page below:
You will notice that on this screen all you need to do is enter the email addresses of the three lists and any customers will automatically be added into your responder system.
This is the final step to integrating GetResponse with your Partner System. Upon entering the required information you may click the button labeled "OK" to save your settings and close the Autoresponder Setup screen (returning you to the default Partner Administration page).